Eaton 3kva E Series Online Double Conversion UPS


Overview of Eaton 3kva E Series Online Double Conversion:

The E Series® DX UPS double-conversion UPS affordably protects mission critical applications from downtime, data loss and corruption. The double-conversion architecture incorporates rectifier and inverter stages to completely isolate the output power from all input anomalies. By adapting to a wide range of input voltages, the E Series DX avoids battery usage during minor power fluctuations, saving its capacity for times when utility power is completely lost.


  • Double conversion topology assures maximum reliability
  • Wide input-voltage range appropriate for the harshest electrical environments
  • Standard Models for fixed-run time performance
  • Tested for generator compatibility
  • Automatic bypass for fault-tolerance
  • Optional SNMP communications provides remote networkbased monitoring
  • XL Models for customised, long run-time applications, with fast recharging
  • Cold start on battery power allows portable power
  • WINPOWER software monitors power conditions
  • Intuitive front-panel user interface for consistent status indication
  • Topology: Online double-conversion IGBT with micro-controller
  • Configuration: Tower
  • Part Number: EDX3000HA
  • Rating (VA/Watts): 3000VA/2100W
  • Efficiency: >85%
  • UPS Bypass: In-Built Automatic Relay Bypass
  • Connection: IEC-320-C20
  • Input Voltage Range: 122V to 300V
  • Nominal Voltage: 220V
  • Voltage Range: 208/220/230/240V
  • Frequency: ’50/60Hz, auto-detection
  • Frequency Range: 46Hz – 64Hz
  • Input Power Factor: > 0.95pf
  • Input Current Distortion: <30% THDi
  • Voltages: 208/220/230/240V
  • Nominal Voltage: 220V
  • Voltage Range: 208/220/230/240V
  • Output voltage regulation: ±2%
  • Output Receptacles: (4) IEC-320-C13,Hardwired – see manual for terminal block layout
  • Power Factor: 0.7
  • Output Frequency: 50 / 60Hz
  • Load Crest Factor: 3:1
  • Battery Description: Valve Regulated Lead Acid, AGM
  • Battery Type: 8x 12V, 7.2 Ah
  • Half Load Runtime (in mins): 16
  • Full Load Runtime (in mins): >5
  • Start On Battery: Unit can be started without being connected to AC utility power — allows for portable power source
  • Recharge Time: < 5 hours to recover 90 percent of nominal backup
  • User Interface: Led’s
  • LEDs: LED mimic diagram with 4 x LEDs for Utility, Bypass, Inverter & Battery Status,
  • Audible Alarms: Battery Operation Mode, Low Battery, General Fault, Overload, On Bypass
  • Communication Ports: 1 off Intelligent-Slot (Empty), 1 x RS232 DB9 Serial Port
  • Power Management Software: WINPOWER power management software, included on CD
  • Audible Noise: <50dB
  • Operating Temperature: 0°C to 40°C
  • Safety markings: CE
  • EMC Markings: IEC/EN 62040-2 Category C3
  • Markings: CE, C−Tick
  • Data Line Protection: Input / output jacks included for telephone / modem / internet line surge protection
  • Storage Temperature: 0°C to 40°C
  • Relative Humidity: 5 to 95%, no condensation allowed
  • Altitude: 1000m above sea level

Based on 0 reviews

0.0 overall

Only logged in customers who have purchased this product may leave a review.

There are no reviews yet.